Sanus VSL4 Manual De Instrucciones página 13

4. Place the wall plate template
17
template and tape in place.
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the two pilot holes using a 5.5 mm (7/32 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 75 mm (3 in.).
6. Remove the wall plate template
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage Do not over-
tighten the lag bolts 20
4
17
at your desired height and position the slotted holes over your stud center line. Level the wall plate
17
. Tighten lag bolts
.
5
17
20
only until they are pulled fi rmly against the wall plate
75 mm
(3 in.)
5.5 mm
(7/32 in.)
18
6
18
17
.
20
13