Maintenance - J.P. SELECTA DOSI-FIBER 4 PLAZAS Manual De Instrucciones

MANUAL DE INSTRUCCIONES CODIGO 80055 REV D OCT2018
J
.P. SELECTA s.a.u.
DO NOT STOP THE PUMP (PRESSURE) WITH THE VALVE IN
15- Wash the samples with warn distilled water using the spray. The
water is introduced in each column inlet. Place the valves in «as-
pirar» position to dry the sample. Close the valves again. If the
method requires more extractions repeat the whole cycle.
16- To remove the crucibles from the extraction unit use the crucible
handle. Insert it in the crucibles and immediately free them using
the lever on the left.
17- Transfer them to the rack «4».
1
2
3

MAINTENANCE

Before removing the cover disconnect the equipment from the
mains.
The manipulation of the internal electronic circuits by
unauthorized personnel can cause irreparable damage. Take it
to one of the J.P.SELECTA s.a.u. authorized technical services.
1- Remove the rear lid of the main unit and find the «soplar» pump
(See page 9, spare part 2)
2- Adjust the pump power throughout the grooved button:
Clockwise: more power.
Unclockwise: less power.
3- This pump is adjusted at maximum power in factory.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: jpselecta@sefes.es - http://www.sefes.es/selecta
(Sujetas a modificaciones sin previo aviso)
«SOPLAR» POSITION.
Tel (34 3) 770 08 77 Fax (34 3) 770 23 62
Pag.: 24
10
9
8
7
6
5
4