ISO DIN head unit provision
with pocket
1. Mount the radio to the brackets
with the screws included with unit.
(Figure A)
2. Mount the pocket to the radio
brackets with the screws supplied.
(Figure A)
3. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
4. Mount assembly into the sub dash.
(Figure B)
5. Reassemble dash in reverse order
of disassembly using 99-2022 trim
panel instead of factory panel.
Continue to Interface Installation
(Figure A)
(Figure B)
99-2023B
Double DIN head unit provisions
1. Mount the radio to the DDIN
brackets with screws included with
unit. (Figure A)
2. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
3. Mount assembly into the sub dash.
(Figure B)
4. Reassemble dash in reverse order
of disassembly using 99-2022 trim
panel instead of factory panel.
Continue to Interface Installation
4
(Figure A)
(Figure B)