Description Of The Appliance And Its Accessories; Preparation; Use - Imetec S0201 Manual De Instrucciones

DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES

Refer to Figure [A] in the Illustrative Guide to check the contents of the package.
EN
1. Cover
2. Thermostat
3. Probuct mody
4. Prodcut base
5. Tchnical dataa
6. Cable with power switch
• Unpack the product.
• Check that it is intact and not damaged.
• Connect the product to the domestic mains.
WARNING! This appliance is not to be used if it has been
dropped or if there are visible signs of damage.
• For fan operation, move the power switch (8) to the cool air position and adjust the ambient
thermostat (2) to the maximum temperature.
• For gradual heating, move the power switch (8) to the Warm air position I or Hot air position
II and adjust the ambient thermostat (2) to the required temperature.
• For quick heating, move the power switch (8) to the rapid heating position III and set the
ambient thermostat (2) on the required temperature.
• To switch the appliance off, turn the power switch (8) to off.
Minimum temperature/ Anti-freeze function (where available)
This function assures maintaining the room temperature at around +5°C. The fan heater turns
on automatically as soon as the temperature falls below this value.
• Adjust the room thermostat (2) to the minimum temperature.
• Turn the power switch (8) to the Warm air mode position I or to the Hot air mode position II
to gradually achieve a temperature of +5°C.
• Turn the power switch (8) to the Rapid heat position III to quickly achieve a temperature of
+5°C
Auto shut off function
The fan heater is equipped with an automatic shutoff function after 1 hour, 3 hours or 9 hours.
When turned on, the green LEDs of the auto shut-off timer display (7b) will flash in sequence.
Press the START / Timer Selector button (7 a) to set the desired sleep time:
• Press once for 1 h auto shut off timer
• Press twice for 3 h auto shut off timer
• Press 3 times for 9 h auto shut off timer
The relevant selections will light up on the sleep timer display (7b).
When the selected time has elapsed, the fan heater will switch off and the stand by LED (7c)
will light up blue.
To reactivate operation, press START / Timer Selector again as indicated above.
14
7. Autoshut off timer
7a. START/Timer selection button
7b. Auto shut off timer display
7c. stand by LED
8. Power selector
9. Function LED

PREPARATION

USE