Thermador PROFESSIONAL PRO HARMONY PRG304H Manual De Instalación página 23

High Shelf Assembly
1. Remove protective plastic.
2. Slide the shelf onto the backguard panel.
Figure 16: High Shelf Assembly Rear View
3. Install the included stainless screws along the topside
of shelf and into the back of the shelf.
4. Begin with Backguard Installation.
Backguard Installation
1. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim.
Figure 17: Flush Island Trim Front Face Screw Removal
English 20
All manuals and user guides at all-guides.com
2. Remove the (4) drill point screws securing the trim to
3. Align the back panel of the new accessory with the
4. Make sure the backguard's front face is outside the
5. Re-install screws removed in Steps 1 and 2.
the side panels, and the (2) to (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove.
Figure 18: Flush Island Trim Rear Screw Removal
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range (Figure 19).
Mounts inside Mounts inside Mounts inside
side panel flange side panel flange side panel flange
Figure 19: Backguard Installation
flange on the front side of the range.