Adjusting The Stands; Power Connection; Water Connection - Beko GNE60531XN Guia Del Usuario

Installation

3.3. Adjusting the stands

If the product is not in balanced position, adjust the
front adjustable stands by rotating right or left.

3.4. Power connection

A
WARNING:
multi sockets in power connection.
B
WARNING:
must be replaced by Authorized
Service.
C
When placing two coolers in adjacent
position, leave at least 4 cm distance
between the two units.
Our firm will not assume responsibility for any
damages due to usage without earthing and
power connection in compliance with national
regulations.
The power cable plug must be easily
accessible after installation.
Connect the refrigerator to an earthed socket
with 220-240V/50 Hz voltage. The socket must
comprise a 10-16A fuse.
Do not use multi-group plug with or without
extension cable between the wall socket and
the refrigerator.
Do not use extension or
Damaged power cable

3.5. Water connection

(Optional)
A
WARNING:
the water pump (if available) during
connection.
The product's water mains, filter and carboy
connections must be rendered by authorized
service.
The product can be connected to a carboy or
directly to the water mains, depending on the
model. To establish the connection, the water hose
must first be connected to the product.
Check to see the following parts are supplied with
your product's model:
1 2
3
1. Connector (1 piece): Used to attach the water
hose to the rear of the product.
2. Hose clip (3 pieces): Used to fix the water
hose on the wall.
3. Water hose (1 piece, 5 meter diameter 1/4
inches): Used for the water connection.
4. Faucet adapter (1 piece): Comprises a porous
filter, used for connection to the cold water
mains.
5. Water filter (1 piece *Optional): Used to
connect the mains water to the product. Water
filter is not required if carboy connection is
available.
8 / 31 EN
Unplug the product and
4 *5
Refrigerator / User Manual