Troubleshooting - Kärcher SPP 33 Inox Manual De Instrucciones

Danger
To avoid risks, all repairs and replacement of spare parts may only be carried out by au-
thorized customer service personnel.
First pull out the plug from the mains before carrying out any tasks on the machine.
Fault
Pump runs but does not
transport
Pump does not run or sud-
denly comes to a standstill
during operations
Pumping capacity is reduc-
ing
Pumping capacity too low
Our Kärcher branch will be pleased to help you further in the case of questions or faults.
See address on the reverse.

Troubleshooting

Cause
Air in the pump
Suction area blocked
(only in manual mode) Water
level below the minimum wa-
ter level
Power supply interrupted
Thermal protection switch in
the motor has switched off the
pump as it was overheated.
Dirt particles have got jammed
into the suction area
Pump operation stopped by
sensor
Suction area blocked
The pumping capacity de-
pends on the flow height, hose
diameter and hose length.
– 6
EN
Remedy
Plug in/ pull out the mains
plug of the pump a few
times till the fluid gets
sucked
Pull out the mains plug and
clean the suction area
Where possible, immerse
the pump deeper into the
liquid or proceed according
to the instructions in the
chapter describing the
preparations necessary for
automatic operation
Check fuses and electrical
connections
Pull out the mains plug, let
the pump cool down, clean
the suction area, prevent
dry running
Pull out the mains plug and
clean the suction area
Check position of level
sensor
Pull out the mains plug and
clean the suction area
Keep max. flow height, see
technical data. If neces-
sary, select a different
hose diameter or hose
length.
17