Dubbing From Tape To Tape - Sharp CD-M10000V Manual De Manejo

Dubbing from tape to tape

You can record from TAPE 1 to TAPE 2.
For recording, use only normal tapes. Do not use metal or CrO tapes.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette compart-
ment. Insert a blank tape into the TAPE 2 cassette compartment.
It is recommended that the recording tape is the same length as the master tape.
3
Press the TAPE (1 2) button until
"TAPE 1" appears on the display.
The reverse mode will be set to " ".
4
Press the REC PAUSE (TAPE-2
button.
Recording will be paused.
5
Press the ( ) button.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
„ Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the display.
3 Set the button to " " to erase only one side and to " " to erase both sides.
4 Press the REC PAUSE (TAPE-2 ) button.
5 Press the ( ) button to erase side A, or the
To erase both sides, begin from side A. (If erasing is started from side B, the tape
will not switch over to side A.)
Note:
Make sure that the TAPE 1 is not in use.
01/10/30 CD-M10000V(X)E4.fm
CD-M10000V
ENGLISH
)
button to erase side B.
E-36
1
2
3
4
5
6
7