Dremel 2050 Instrucciones De Funcionamiento página 21

2610Z09741 12-17 2050.qxp_2050 12/19/17 10:39 AM Page 21
EZ Drum™ Mandrel No. EZ407SA has a
spring loaded sleeve and is used with
sanding bands.
disconnect the plug from the power
source or the battery pack from the tool
before changing accessories. Such
preventative safety measures reduce the risk
of starting the power tool accidentally.
Always make sure accessory is properly
seated on mandrel before use. Incorrect
seating of accessory on mandrel may lead to
personal injury or property damage.
To load accessory:
1. As indicated, place two fingers underneath
the mandrel and pull firmly up. This will
place the EZ Drum™ in the "unlocked"
position (Fig. B1).
2. Keeping two fingers beneath the mandrel,
slide the sanding band down until the
entire blue mandrel is covered (Fig. B2).
3. To return to "locked" position, press firmly
down on the top of the mandrel (Fig. B3).
Removing the sanding band on
the mandrel:
1. Place two fingers underneath the mandrel
and pull firmly up. This will place the EZ
Drum™ in the "unlocked" position (Fig.
B1).
2. Sanding band will now easily slide off
mandrel (Fig. B2). Do not squeeze
sanding band when removing from EZ
Drum™ mandrel. This can lead to rubber
band pulling off mandrel and becoming
inoperable.
EZ Drum Operating Instructions
™
Always make sure the
rotary tool is "OFF" and
FIG. B1
FIG. B2
FIG. B3
21