Additional Safety Warnings - Dremel 2050 Instrucciones De Funcionamiento

2610Z09741 12-17 2050.qxp_2050 12/19/17 10:38 AM Page 6
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can
cause kickback.
Safety warnings specific for wire
brushing operations:
Be aware that wire bristles are thrown by
the brush even during ordinary operation.
Do not overstress the wires by applying
excessive load to the brush. The wire bristles
can easily penetrate light clothing and/or skin.
Bit may become a projectile and cause serious
injury.
GFCI and personal protection devices like
electrician's rubber gloves and footwear will
further enhance your personal safety.
Use only power supply number 2610Z09738
provided with the tool.
Keep handles dry, clean and free from oil
and grease. Slippery hands cannot safely
control the power tool.
Use clamps or other practical way to secure
and support the workpiece to a stable
platform. Holding the work by hand or against
your body is unstable and may lead to loss of
control.
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be
careful not to disassemble any portion of
the tool since internal wires may be
misplaced or pinched or safety guard return
springs may be improperly mounted.
Certain cleaning agents such as gasoline,
carbon tetrachloride, ammonia, etc. may
damage plastic parts.
6
Safety Rules for Rotary Tools - (cont.)

Additional Safety Warnings

Do not use router bit
with the Dremel chuck.
Allow brushes to run at operating speed for
at least one minute before using them.
During this time no one is to stand in front
or in line with the brush. Loose bristles or
wires will be discharged during the run-in time.
Direct the discharge of the spinning wire
brush away from you. Small particles and tiny
wire fragments may be discharged at high
velocity during the use of these brushes and
may become imbedded in your skin.
Risk of injury to user. The power cord must only
be serviced by a Dremel Service Facility..
Some dust created by
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.