Dremel Micro 8050 Instrucciones De Funcionamiento Y Seguridad página 25

DM 2610031565 05-14-v8_8050 5/13/14 11:46 AM Page 25
EZ Lock™ Mandrel No. EZ402 has a spring
loaded sleeve and is used with cutting wheels,
abrasive buffs and polishing cloth.
Always make sure the rotary
W RNING
tool is "OFF" before changing
accessories. Incorrect seating of wheel on
mandrel may lead to personal injury orproperty
damage.
To load accessory:
1. Place EZ Lock™ mandrel into chuck as
deep as possible as described on page 12.
Note: there is a blue spacer on the mandrel
that will bottom out on the EZ Change™
chuck, setting the mandrel to the correct
depth.
2. Pull spring-loaded sleeve DOWN towards
tool with one hand and hold. You can brace
the tool on the body or work-bench for extra
leverage (Fig. 1).
3. With the other hand, align bowtie shape on
cut-off wheel with mandrel and make sure
metal insert is facing away from the tool (Fig. 2).
4. Place wheel on the mandrel to a point just
below the bowtie on the mandrel and twist
90 degrees until the bowtie shape on the
wheel aligns with the sleeve. Release
sleeve. Wheel should lock in place (Fig. 3).
5. When mounting sanding and polishing
accessories, align bowtie with metal insert
on bottom of accessory (Fig. 4 & 5).
To check for proper seating, hold collet lock
button and twist accessory. Accessory will not
be able to rotate on mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward
tool with one hand (Fig. 1).
2. Hold sleeve down while twisting accessory
90 degrees.
3. Remove accessory.
During use
Avoid damage to EZ lock™ mandrel by not
letting it contact the workpiece.
EZ Lock Operating Instructions
™
FIG. 1
FIG. 2
FIG. 3
90˚
FIG. 4
FIG. 5
90˚
25