SteelSeries ARCTIS 7X WIRELESS Guía De Información Del Producto página 37

accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement, the device can be used in portable exposure
condition without restriction.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Headset FCC ID: ZHK-HS00013
Transceiver FCC ID: ZHK-HS00021TXX
Frequency bands and Powers (Mouse and Transceiver)
a. Frequency band(s) in which the radio equipment operates: 2.400 - 2.4835 GHz
b. Maximum radio-frequency power transmitted in the
frequency band(s) in which the radio equipment operates:
• Conducted Peak Power/ л/4-DQPSK: 4.88 dBm (Headset ANT 1)
• Conducted Peak Power/ л/4-DQPSK: 4.9 dBm (Headset ANT 2)
• Conducted Peak Power/ л/4-DQPSK: 5.45 dBm (Transceiver)
c. Firmware Version: T1.00.05
Regions Contact Information
USA SteelSeries ApS., 656 W Randolph St., Suite 3E, Chicago, IL 60661, USA
Industry Canada Statement:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
More information and support from
+1 312 258 9467
https://steelseries.com/
36