Maintenance - Stanley STHT77502-1 Manual Del Usuario

Using the Laser with the Bracket
GB
A bracket (Figure
H
you can easily attach the laser to a stud, ceiling grid,
or pole.
Securely attach the laser to the bracket.
1.
• Using the 1/4-20 thread on the bottom, side,
or back of the laser (Figure
laser on the 1/4-20 thread on the bracket arm
(Figure
H 1
• Turn the laser knob (Figure
to lock the laser on the 1/4-20 thread on the
bracket arm.
If needed, change the height or position of the
2.
laser on the bracket.
• Turn the adjustment knob (Figure
counter-clockwise to loosen the bracket arm.
• Slide the bracket arm up or down to the desired
height (Figure
from 90° to 180°, slide the bracket arm to the
top of the bracket and then flip the arm to the
right (Figure
• Turn the adjustment knob (Figure
clockwise to lock the bracket arm in place.
Use the bracket's clamp (Figure
3.
the laser in place on a stud, ceiling grid, or pole.
• If necessary, rotate the clamp so it is positioned
at the correct angle for attaching to the object.
While holding the bracket arm with one hand,
use your other hand to turn the clamp
(Figure
H 7
• Position the bracket's clamp around the stud,
ceiling grid, or pole.
• Turn the clamp knob (Figure
until the clamp is tight around the object and
the bracket is held in place.
14
) is included with the laser so
), position the
C
).
) clockwise
H 2
H 3
). To change the bracket
H 4
).
H 5
H 3
) to hold
H 6
).
) clockwise
H 8
Using the Laser with Other
Accessories
WARNING:
Since accessories other than those offered
by STANLEY have not been tested with this
laser, use of such accessories with this laser
could be hazardous.
Only use STANLEY
recommended for use with this model. Accessories
that may be suitable for one laser may create a risk of
injury when used with another laser.
The laser is equipped with a 1/4-20 female thread on
the bottom, side, and back (Figure
to accommodate current or future STANLEY
accessories.
)
Other recommended accessories for use with this
laser are available at extra cost from your local dealer
or authorized service center. If you need assistance
locating any accessory, please contact your nearest
STANLEY service center or visit our website:
http://www.STANLEY.com.
)

Maintenance

• When the laser is not in use, clean the exterior parts
with a damp cloth, wipe the laser with a soft dry
cloth to make sure it is dry, and then store the laser
in the kit box provided.
• Although the laser exterior is solvent resistant,
NEVER use solvents to clean the laser.
• Do not store the laser at temperatures below -5 ˚F
(-20 ˚C) or above 140 ˚F (60 ˚C).
• To maintain the accuracy of your work, check the
laser often to make sure it is properly calibrated.
• Calibration checks and other maintenance repairs
may be performed by STANLEY service centers.
accessories that are
®
)
C
®