Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Peel back 2" of the liner on the Body Side moldings.
See Figure 1B.
3. Place Body Side Molding into position and check for correct
fit.
4. Carefully remove the remaining liner from the Body
Side Molding.
FIGURE 1B
BODY SIDE MOLDING REAR (RH)
Body Side Molding
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x
11 WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EX-
CLUDING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
5. Using a roller, apply pressure to the part to press the
tape onto the doors.
NOTE: CARE SHOULD BE TAKEN NOT TO
DAMAGE THE PAINT FINISH.
MASKING TAPE
BODY SIDE MOLDING
IR 26JA07
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Chevrolet Corvette
Body Side Molding
PART NO.
19171056
6200 Grand Pointe Dr., Grand Blanc, MI 48439
2"
(50mm)
19171056
SHEET
2
SHEET
2
6
OF
6
OF
Publicidad
Tabla de contenido
