Changing The Dust Collection Cartridge - Kemper MaxiFil Clean Instrucciones De Servicio

NOTE
Products with IFA certification according to requirements for W3/IFA
certified welding fume separation class. (See "Technical data" chapter)
The IFA approval becomes void if:
• The product is used other than as intended or is subject to
constructive modifications.
• Non-original spare parts, in accordance with the spare parts list, are
used.
NOTE
Please also refer to the "Installation" and "Use" chapters for the following
stages.
• Only original replacement filters, because they guarantee the necessary
filter efficiency and are matched to the product and its performance
characteristics.
• Switch the product off at the device switch.
• Prevent unintentional restarting by disconnecting the mains plug.
• Disconnect the pressure supply and let the compressed air present in
the product flow out via the condensate drain valve.

7.2.2 Changing the dust collection cartridge

The fill level in the dust collection cartridge is continuously monitored and
when a set fill level is exceeded, this is indicated by the signal lamp flashing
5 times and the product also switching off at the same time.
WARNING
Emptying the dust collection cartridges is not permitted. This inevitably
leads to contamination of the environment by stirred-up dust particles.
Only use original dust collection cartridges, as only these guarantee
proper storage of the collected dust particles,
1502827-03 - 67 -
EN