Changing The Filter - Safety Instructions - Kemper ProfiMaster Instrucciones De Servicio

7.2.1 Changing the filter – Safety instructions
The life of the filter inserts depends on the type and amount of deposited
particles.
As the dust accumulation in the filter increases, its flow resistance
increases and the extraction capacity of the product decreases.
Even in the case of products with an automatic filter cleaning system (if
present), deposits can reduce the flow resistance.
A filter change is required.
WARNING
Health hazards caused by welding fume particles
Inhalation of welding fume particles, especially welding fume particles
from welding processes on alloyed steels, can damage your health as
they are 'respirable'. Skin contact with welding fume particles can cause
skin irritation in sensitive individuals.
To avoid contact with and inhalation of these dust particles, wear
disposable overalls, protective goggles, gloves and a suitable Class FFP2
respiratory protection filter mask in accordance with EN 149.
WARNING
Cleaning the filter inserts is not permitted. This inevitably leads to
damage to the filter element, meaning the filter ceases to function and
hazardous substances enter the air.
During the work described in the following section, pay particular
attention to the seal on the main filter. Only an undamaged seal allows
the product to achieve a high filter efficiency. Main filters with a damaged
seal must therefore be replaced every time.
1502763-02 - 68 -
EN