Adjusting The Chain Lubrication; Checking The Chain Brake - Makita XCU07 Manual De Instrucciones

1. Switch trigger 2. Lock-off lever

Checking the chain brake

CAUTION:
Hold the chain saw with both
hands when switching it on. Hold the rear handle
with your right hand, the front handle with your
left. The bar and the chain must not be in contact
with any object.
CAUTION:
Should the saw chain not stop
immediately when this test is performed, the
saw may not be used under any circumstances.
Consult our authorized service center.
1. Press the lock-off lever, then pull the switch trig-
2. Push the front hand guard forwards with the back
of your hand. Make sure that the chain saw comes to an
immediate standstill.
2
1
1. Front hand guard 2. Unlocked position 3. Locked
position
1
3
1
2 3
Checking the run-down brake
2
CAUTION:
within one second in this test, stop using the
chain saw and consult our authorized service
center.
Run the chain saw then release the switch trigger com-
one second.

Adjusting the chain lubrication

universal wrench.
1.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
bare hands. Always wear gloves when handling
the saw chain.
Removing or installing saw chain
CAUTION:
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
1. Release the chain brake by pulling the front hand
guard.
10 ENGLISH
If the saw chain does not stop
1
Always be sure that the tool is
Do not touch the saw chain with
The saw chain and the guide bar