Russell Hobbs 28040-56 Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
IMPORTANT INFORMATION
For best performance, we recommend using distilled, purified or filtered water in your steamer. Tap
water contains minerals that can build up inside your steamer over time and reduce its efficiency or
even cause damage.
Never use perfumes, oils or other additives.
Always check the garment's care label before steaming, and always test fabrics for colourfastness in
an inconspicuous area. Steamers are not recommended for use on leather, suede, vinyl, plastic, or
other materials that are sensitive to steam.
During use the steamer and accessories will become HOT. Never try to fit or remove attachments
while still hot.
After preheating, prime the water pump by holding the steam trigger until steam forms.
It is normal to feel or hear the water pump inside the device. It may become louder when the water
level in the tank is low. Check and refill the tank when required.
Small amounts of dripping might occur during use. If excessive, your steamer needs time to get back
up to full temperature. Just allow the steamer a minute to reheat.
Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always allow the
clothing to cool for about 5 minutes before wearing.
ATTACHMENTS
Your steamer has three attachments:
Lint attachment
Delicate fabric attachment
with scent infuser
Upholstery attachment
Fitting/Removing (Fig. A)
1.
Make sure that the steamer and attachment are cool.
2.
Hook the top of the attachment over the top edge of the steamer. Click the bottom edge into place.
Make sure it is fully fitted and not loose or it may detach itself during use.
3.
Remove the attachment using the tab. When removing the attachment, watch out for condensation
that may have built up during use.
FILLING
1.
Place the steamer on its base on a stable surface.
2.
Pull out the removable water tank (Fig. B)
3.
Gently open the rubber cover at the top of the tank.
4.
Fill until the water reaches the "MAX" level mark on the side of the tank (Fig. C). Do not overfill. Close
the rubber cover securely.
5.
Dry off any excess water from the tank then refit it into the base until it clicks.
To refill at any time during use, turn the steamer off by pressing the power button until the blue
indicator light goes out, unplug from outlet, and follow the above procedure.
After refilling, allow to reheat for 45 seconds and then prime the pump by holding the steam trigger
until steam forms.
Use on garments labelled k l that allow the use of steam.
Tip: The pad on the attachment helps remove lint, hair, and animal fur.
Use on garments labelled j that allow the use of steam.
Tip: For items with printing/embellishment, turn the garment inside out to
avoid damage to sensitive areas.
Use the scent infuser to infuse your favourite perfumes onto your fabrics.
Use to sanitise and refresh bedding, mattresses, curtains, plush toys,
furniture, and hard surfaces (such as worktops or desks that are not heat
sensitive).
Always test for colourfastness and heat sensitivity on an inconspicuous area.
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
UA
AE

Publicidad

Tabla de contenido
loading

Tabla de contenido