Fuse Replacement; Troubleshooting - Klarstein 10031083 Manual De Instrucciones

Push both side of the fuse capsule towards each other and twist it
to open the fuse capsule.
Remove the damaged 5A glass fuse from the capsule then repla-
ce a new 5A glass fuse.
To close the fuse capsule aline the latch and groove then push in
and twist to lock the fuse capsule.
Problem
Fan will not start.
Fan excessively noisy. Check that all screws in fan assembly are tight and properly seated.
Fan wobbles.

Fuse Replacement

Troubleshooting

Possible Cause and Solution
Check fuse or circuit breaker and replace if necessary.
Turn off electrical power, check all wire connections.
Check to make sure the dip switches from the transmitter and receiver are set on
the same frequency.
Check to make sure mounting bracket is installed properly.
Check that all blades are screwed firmly into blade brackets.
If the above mentioned remedies can't eliminate the wobble, use the clip from
balance pack to make sure the position. Stick the balancing weight on the opposite
side of the mark place.
If the above mentioned remedies can't eliminate the wobble, interchange the blade
pair, proceeding as following illustrations until wobble is removed.
20