Installation - Klarstein 10031083 Manual De Instrucciones

IMPORTANT: Do not install the fan onto the partition ceiling or chapped wall.
The ceiling fan must be mounted
at a min. height of 7.5 ft/2.3 m of
1
clearance from the floor.
The mounting bracket must be
securely fastened to a structural
ceiling member.
2
Please choose one of the following
ways to install the mounting bracket.
Make sure all screws are tightened.
Loosen 2 screws at the yoke of the
motor assembly. Slide the canopy
into the downrod. Thread the
power leads from the fan through
the canopy, decorative cover and
downrod (take extra care not to pull
power wires damage). Set downrod
into yoke and rotate until the holes
match. Then, insert lock pin through
3
the holes and firm it with R pin.
Tighten 2 screws and nuts at the top
yoke of the motor assembly.
ATTENTION: Make sure the R pin
and lock pin is proper and secure
to prevent the fan from falling
or causing property damages or
personal injury.

Installation

14