BURY CC 9056 Plus Guía Rápida página 19

19
PWR/LSP/LINE OUT
Step 1:
Pull the ISO jacks at the back of the radio off and replace them with the jacks at the ISO cable harness. Connect
the now free ISO jacks with both sockets from the ISO cable harness (see picture). 15
If you want music or voice signals to be fed via the four LINE cables, you must adjust them accordingly to the
respective type of radio and its connections (PHONE-IN or AUX-IN). Appropriate adapters are available from
specialists shops.
Step 2:
The hands-free car kit supports the radio mute function, if this function is also supported by the radio. The mute
signal is then fed to the radio via the yellow cable of the ISO cable harness. The cable is labelled with "mute"
and must be connected to one of the three sockets (mute1, mute2, mute3). Please observe the notes on this
topic in the instruction manual of the radio concerning "Pin allocation for mute / radio mute". Then, connect the
mute cable to the corresponding socket. 16
Step 3:
Insert the 24-pole molex jack (A) into the connection of the electronic box (see picture). 16
Connection diagram for ISO cable harness 17