Manuale Per L'uso - GRAPHITE 58G602 Instrucciones De Uso

CAUTION: BEFORE USING THE POWER TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE
REFERENCE.
DETAIL SAFETY RULES (MULTI PURPOSE TOOL)
●
During operation hold the tool firmly in closed hand.
●
Before switching the tool on make sure it does not touch processed material.
●
Before cutting floor, wall or other surface make sure the cut area is free from gas or electric installation.
Cutting a live wire may cause electric shock and cutting gas pipe may cause explosion.
●
Do not touch moving parts of the tool.
●
Do not put the tool aside before it stops completely.
●
Hold the tool firmly in your hand before switching it on.
●
Do not touch blade and processed material just after the work has been finished, these pieces may be
very hot and may cause burns.
●
To replace blade or sanding paper, first switch the tool off with the switch and wait until it stops
working, then disconnect the tool from mains socket.
●
Prior to operation check if there is enough space under processed material to avoid table or floor
damage with the blade.
●
Use anti-dust mask. Dust produced during operation is harmful to health.
●
Do not eat, drink or smoke in a room, where paint with lead compounds is removed with this tool.
There should be no bystanders in the room. Contact with or inhalation of dusts with lead compounds
may be harmful to health.
●
Before sanding connect dust extraction system to the tool.
●
The tool is not designed for wet operation.
●
Keep the power cord away from moving parts of the tool at all times.
●
When you see unusual behaviour of the tool, smoke or hear strange noises, immediately switch off the
tool and remove the plug from mains socket.
●
To ensure proper cooling during tool operation keep the ventilation holes unobstructed.
CAUTION! This device is designed to operate indoors.
The design is assumed to be safe, protection measures and additional safety systems are used,
nevertheless there is always a small risk of injuries at work.
CONSTRUCTION AND USE
Multi purpose tool is driven by single-phase motor whose rotation is changed to oscillations. Various
working tools available for the tool allows for use in various types of tasks. This type of power tool is widely
used for: cutting wood, wood-based materials, plastics, non-ferrous metals and joining parts (nails, bolts
etc.).
It can also be used to process soft ceramic tiles, sanding and dry scraping small surfaces. Possibility of
processing abovementioned materials in hardly accessible places and close to edges is an advantage of
the tool.
Range of use covers the following tasks: small model making, locksmith, woodworking and any work from
the scope of individual, amateur activities (tinkering).
Use the power tool according to the manufacturer's instructions only. Use the power tool only with
original equipment.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. Sanding pad
ORIGINAL MANUAL (INSTRUCTION)
MULTI PURPOSE TOOL
59G020
DETAILED SAFETY REGULATIONS
11