GRAPHITE 58G602 Instrucciones De Uso página 79

INSTALLATION AND REPLACEMENT OF SANDING PAPER
Sanding pad is equipped with hook-and-loop attachment system for quick and easy replacement of
sanding paper. Choose sanding paper with appropriate gradation depending on the processed material
and desired level of material removal. All types of sanding paper, abrasive cloths and polishing felt are
allowed.
Use only appropriate sanding paper with holes (perforated).
● Put the sanding paper close to the sanding pad (1).
●
Place the sanding paper so its holes (
●
Press the sanding paper against the sanding pad (
●
Make sure that the holes on the sanding paper and sanding pad fully match; it ensures optimal
conditions for dust extraction.
●
To remove sanding paper, lift edge of it on one side and pull (
INSTALLATION OF WORKING TOOLS
● Remove working tool if already installed.
●
Use hexagonal key to unscrew the fixing screw (
●
Place working tool in the tool holder, make sure to close latch joint of the tool and tool holder.
●
You can place working tools onto the tool holder in any latching position (
most comfortable and safe for the user.
●
Working tool should be installed with bend pointing down.
●
Place washer and tighten the screw (
Check that the tool is installed properly. Improperly or inaccurately installed working tools can slip
during operation and cause risk for the user.
DUST EXTRACTION
Dust of some materials may be hazardous to health, like paint coatings with lead additives, some
types of wood e.g. oak or beech or materials with asbestos. Therefore, we recommend use of external
dust extraction systems, good workplace ventilation and use of dust-mask with particle filter.
The tool is equipped with dust extraction add-on, which should be connected to external dust extractor
after installation, e.g. vacuum cleaner designed for the type of produced dust.
● Remove working tool if already installed.
●
Install dust extraction add-on (
●
Connect suction hose, e.g. vacuum cleaner to the adaptor (
●
Install working tool in the tool holder.
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the label of the tool.
Switching on – slide the switch (2) forward to position I (fig. C).
Switching off – slide the switch (2) backward to position O.
Do not cover holes for motor ventilation in the tool body.
PRINCIPLES OF OPERATION
Oscillation frequency 20 000 rpm at 2.8° angle allows to work precisely in small areas and corners with the
power tool.
SAWING AND CUTTING
Use only undamaged working tools in good technical condition.
When sawing or cutting wood, fibre board, wood-based materials etc. make sure they do not contain
foreign objects like nails, bolts etc before starting the task. Remove foreign objects or use proper
blade for removal. You can make plunge cuts only in soft materials like wood, gypsum boards and
alike.
Cutting ceramic tiles causes faster wear of working tool.
a) match with the holes on the sanding pad (1).
1).
6), remove washer and remove the working tool.
6) to install working tool.
5) and fix with clamp (4).
OPERATION / SETTINGS
13
fig. A).
fig. B) to allow for operation
3) of the dust extraction add-on (5).