Control Panel Components - Westinghouse WGen9500c Manual De Usuario

CONTROL PANEL COMPONENTS

1. Push-Button START/STOP: Push once to
automatically start the engine. Push again to stop
the engine.
2. Battery Switch: Turns battery ON and OFF. Must be
ON before electric or remote start.
3. Smart Switch Outlet: Connects the Westinghouse
ST Switch (sold separately) to the control panel.
4. USB Ports: Two-port 5V/2.1A USB outlet. Accepts
Type A USB plugs.
5. Main Circuit Breaker: The main circuit breaker
controls total output of all outlets to protect the
generator from overload or short circuit.
6. 120 Volt AC, 20 Amp Duplex GFCI NEMA 5-20R
Receptacles: Receptacles can supply a maximum of
20 Amps.
7. 120/240 Volt AC, 30 Amp NEMA 14-30R Twist-
Lock Receptacle: Receptacle can supply a
maximum of 30 Amps.
8. 120/240 Volt AC, 50 Amp NEMA 14-50R
Receptacle: Receptacle can supply a maximum
of 50 Amps.
COMPONENTS
9. Ground Terminal: The ground terminal is used to
externally ground the generator.
10. 30 Amp AC Circuit Breakers: Circuit breakers
limits the current that can be delivered through each
leg of the NEMA 14-30R receptacle to 30 Amps.
11. 20 Amp AC Circuit Breakers: Circuit breakers
limits the current that can be delivered through the
NEMA 5-20R receptacles to 20 Amps.
12. Data Center: Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
13. Battery Charging Port: Used to charge the battery
with the included battery charger.
14. Battery Indicator: Indicates that power is ON. Light
will remain illuminated while the unit is ON.
15. CO Sensor indicator lights: The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
Westinghouse Outdoor Power Equipment, LLC | 11