Equipment Setup And Use; Prior To Use; Setup - AMATECH I-ABMT1FH Instrucciones De Uso

INSTRUCTIONS FOR USE
3

Equipment Setup and Use:

Prior to use:

a. Inspect the product looking for any visible damage or sharp edges that could be
caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.
c. Ensure the patient is safely positioned on the OR table before using the Advanced
Arm Support.

Setup:

 To Install: Insert the Support Rod into an Clip-on™ Socket clamp. Tighten the
Accessory Lock Knob securely to prevent the Support Rod from rotating.
 To Adjust Length: Pull the Armboard Extension Sleeve.
 To Adjust Radial Angulation: Unlock the Board Clamp Handle and move the
Armboard to the desired location. Retighten the Board Clamp Handle to
secure the board in the new position.
 To Adjust Height: Vary the amount of the Support Rod that is inserted into the
Clip-on™ Socket clamp.
Equipment Uses
Ensure patient and device are fully supported before adjusting any
joints.
If further device positioning is needed after patient placement, ensure
the arm is fully supported during movement.
Document Number: D-720440
Version: C
Page 12
Issue Date: 18 MAR 2020
Ref Blank Template: 80025118 Ver. E