extending your gate
fig. 5
7
82cm - 89c m
89cm - 96c m
7
28
14
28
110cm - 117c m
117cm - 124c m
(See fig. 5)
For maximum stability you should try and achieve your required width using a minimum
number of extensions (i.e. 1 x 14cm is preferred to 2 x 7cm), if 2 or more extensions are fitted on
the same side make sure the 7cm extension is closest to the gate (furthest away from the wall).
Some suggested configurations are pictured.
(See fig. 6)
To fit your extension system (available separately) first remove the two screw adjusters (B)
from the side of your gate. Prise the plastic bungs (G) from each corner of your gate from
below using a flat screwdriver. Push the extension into place and press the plastic bungs
back into your extension. Slide the screw adjusters back into place and fit your safety gate
as instructed in the 'fixing your gate and fixing cups' section. If a second or third extension
is required, repeat this procedure on the other side of your gate. In the UK, extensions can
be purchased by calling 0871 702 1000; non-UK customers, please contact your retailer. Note:
fixing cups must still be used when using an extension.
fig. 6
5
14
7
14
96cm - 103c m
103cm - 110c m
14 7
28
28
124cm - 131c m
131cm - 138cm (MAX)
G
C
B
G
using your mothercare safety gate
(See fig. 7)
To open your gate: squeeze the two buttons and push down the handle.
fig. 7
28
28
To close your gate: Once you have walked through the gate, check there is no one coming
through behind you and push or swing the gate closed until it locks itself in the closed
position. Always check the gate has properly closed. There is a gate stop at the bottom of
your gate which may be set to restrict the opening of the gate to one direction only. It also
acts as a further locking device which should be used, especially on stairs (see fig. 3 section).
Check the fitting of your gate daily to ensure it remains securely fixed and that all
attachments and locking devices are operating correctly.
6