HIKOKI NP 18DSAL Instrucciones De Manejo página 23

7. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig. 5)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The Table 1 shows the state of remaining
battery indicator lamp and the battery remaining
power.
Table 1
State of
Battery Remaining Power
lamp
The battery remaining power is enough.
The battery remaining power is a half.
The battery remaining power is nearly empty.
Re-charge the battery soonest possible
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
○ Do not give a strong shock to the switch panel or break
it.It may lead to a trouble.
○ To save the battery power consumption, the remaining
battery indicator lamp lights while pressing the
remaining battery indicator switch.
8. How to use the LED light
Every time you press the light switch on the switch
panel, the LED light lights or goes off . (Fig. 6)
To prevent the battery power consumption, turn off the
LED light frequently.
CAUTION
Do not expose directly your eye to the light by looking
into the light.
If your eye is continuously exposed to the light, your
eye will be hurt.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 5 minutes.
Status
Overload State
High Temperature State
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
9. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
○ When using the hook, hang up the power tool fi rmly not
to drop accidentally.
If the power tool is dropped, it may lead to an accident.
○ Make sure the battery removed when using the hook.
○ Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 7)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power tool and
tighten the screws to fi x the hook fi rmly. (Fig. 8)
10. LED light warning signals
This product features functions that are designed to
protect the tool itself as well as the battery.
While the switch is pulled, if any of the safeguard
functions activate during operation, the LED light will
blink as described in Table.
When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and
follow the instructions described under corrective
action.
Remove the battery and clean the area around
the blade guide and drive blade according to
the instructions on page 24 "MAINTENANCE
AND INSPECTION".
Allow the tool to fully cool down.
23
English
Corrective Action