Nikon DSB-N1 Manual De Instrucciones página 16

Attaching the cable release
En
There are two screw holes on 2 shutter release base A. Select the
correct screw hole where the cable release is attached, according to
the camera in use. (Fig. 12)
The screw hole on the left-hand side is for J1/J2 and the one in the
middle is for V1.
Screw the end of the cable release into 5 cable release socket.
1.
(Fig. 13)
2. After pressing the cable release, make adjustments so that the
end of the cable release will be located in the middle of the
camera's shutter release button.
Loosen 3 attaching knob for shutter release base A or c
attaching knob for shutter release base B, and make fine
adjustments to 2 shutter release base A or 4 shutter release
base B. (Fig. 14)
Attaching the light shielding rubber sheet
The supplied light shielding rubber sheet is used as needed to reduce
sunlight or other light that enters the camera.
Hook the holes of the light shielding rubber sheet onto 8 attach-
1.
ing projections for light shielding rubber sheet. (Fig. 15)
[Note]
Make sure that the camera lens will not come in contact with the
eyepiece or 0 eyepiece (DS mount) insertion at the time of
readjusting the camera position in the forward direction or oper-
ating the zoom after the light shielding rubber sheet is attached.
30
Fig. 12 Fig. 13
J1/J2 V1
2 5
2
2
Fig. 14
3
8
Fig. 15
8
Shooting precautions
• Use a sturdy tripod to minimize shaking when taking photos.
• Vignetting or shadows may result depending on relevant conditions, such as the camera model and the type of eyepiece to
be attached or the attaching position or zoom position of the camera.
• Vignetting or shadows may not be perfectly eliminated. Carefully make optimum position settings in order to minimize
vignetting and shadows.
• If you cannot focus on the subject using the AF function, lock the AF and set the focus again using the focus ring of the
fieldscope while viewing the LCD monitor or viewfinder of the camera.
• A shallow depth of field will result because of high-magnification shooting. Pay sufficient attention to focusing.
• If you notice external light on the LCD monitor or image (picture), use the supplied light shielding rubber sheet to prevent
light entering between the mount and lens of the camera. If light still enters, cover the whole equipment with a shield such
as a black cloth.
• The camera position may become misaligned during camera operation. Before releasing the shutter, confirm the existence
of vignetting and shadows and adjust the camera if necessary.
• Do not use the flash when shooting.
• When shooting, select the vibration reduction function OFF from the Nikon 1 menu.
• Noise in the form of lines may appear in pictures depending on the shooting condition.
• When replacing the batteries or recording media, the camera may or may not need to be removed from the connected
equipment depending on the camera. In any case, readjustments to the mounting position are necessary.
En
31