ABANTERA 135I13T20NT Manual De Usuario página 21

Installation
1
Plug in the charger adapter and
wind up the excess cable.
2
Place the charging base flush with the
wall and connect the plug.
3
Do not move the charging base arbitrarily or place in direct
sunlight.
4
Place the left (L) and the right (R) brushes in the holders corresponding to L and R. Press on
the L and R. The side brushes are attached when you hear a click.
R
Image of rotation brushes
INST ALLA TION
ATTENTION
Leave a space of more than 50 cm on either
side of the charging base and a space of
more than 150 cm in front.
If the power supply line is vertical to the ground, the
robot can drag it, resulting in the charging base being
turned off.
The charging display is normally lit when charging
and off when fully charged.
Direct sunlight interferes with the recharge signal,
which may result in the robot being unable to return
to the charging base.
U N I T E D S TAT E S
L
| 19