ABANTERA 135I13T20NT Manual De Usuario página 25

9
Starting and charging
When the robot has finished
running, press the button in the
middle of the water tank in order
to remove the scrub module from
behind, drain the water from the
water tank and clean the cleaning
mop. (do not move or turn the
robot over during cleaning).
10
Instructions for cleaning head module
1. Do not use the cleaning head module when unnecessary.
2. For safety reasons, be sure to remove the cleaning head module when it is charged or not in
use.
3. Do not use the mop on carpet.
4. To achieve a better clean, the cleaning head module should be installed after sweeping the
floor three times.
5. To add water or clean the cleaning mop when the machine is running, pause it, then remove
and reassemble the cleaning head module according to steps 8 and 9. Do not move or turn
over the robot in order to avoid possible failure in positioning or loss of charting capabilities.
6. The cleaning functions of the machine are to clean and to promote deep cleaning. It cannot
effectively remove stubborn stains or replace manual labor.
ON / OFF
Hold down the
indicator light and the machine turn on.
Hold down the
the machine is in standby mode, the indicator
light and the machine are turned off.
(2 in 1 water tank with electric control)
button for 3 seconds. The
button for 3 seconds. When
U N I T E D
INST ALLA TION
Pull gently
ATTENTION
The machine cannot be turned off when
the robot is charging.
S TAT E S
| 23