ABANTERA 135I13T20NT Manual De Usuario página 30

Operation
The ABANTERA
perform the basic cleaning functions and return the robot to the charging base. The remote
(included) has even more functions that are detailed in this manual.
It is important that the robot is charged in order to start cleaning. Place it on the charging base
as indicated in the image at the bottom of the page and press the power button for 3 seconds.
The light will blink until it is a solid orange.
It is important to remove all cords, loose items and delicate objects (vases, glass objects, etc.) that
could be dragged and cause falls or other accidents.
Starting to clean (Automatic Mode)
Press the
making a zigzag path and memorizing the base lines that have already been cleaned in order not
to repeat the path.
The intelligent robot traces a route, recalculating the areas and zones. During this process, the
robot should not be interrupted.
In addition to its many features, the robot also has an advanced self-
charging system, returning to its base to recharge the battery when it is
running out of power.
Once in the charging base, the robot provides notification that it is fully
charged through the continuous blinking of both buttons.
Return to the charging base
At any time, you can press the (home) button
immediately, moving into position and charging the battery.
ATTENTION
If the robot has the water tank
installed, it must be removed.
28 |
Robot has two buttons on top
135I13T20NT
button so that the robot comes out of its base and starts cleaning automatically,
with which you can
and the robot will return to the charging base
U N I T E D S TAT E S
OPERA TION
2 cm