Maytag 4GMVWX500 Manual De Uso Y Cuidado página 16

TROUBLESHOOTING
f
if you experience
Not cleaning or
removing stains
First try the solutions suggested here to possibly avoid a service call.
Possible Causes
Not using correct cycle for
fabric type.
Not using dispensers.
Not washing like colors
together.
Small amount of water Normal dispenser operation.
still in dispenser after
cycle
Incorrect dispenser
operation
Clogged dispensers or laundry
products dispensing too soon.
Residual powder in dispenser.
Solution
Use a higher soil level cycle option and warmer wash temperature to
improve cleaning.
If using Rapid Wash cycle, wash only a few items.
Use Power Wash, Whites, or Heavy Duty cycle for tough cleaning.
See the "Cycle Guide" to match your load with the best cycle.
Use dispensers to avoid chlorine bleach and fabric softener staining.
Load dispensers before starting a cycle.
Avoid overfilling.
Do not add products directly onto load.
Wash like colors together and remove promptly after the cycle
is complete to avoid dye transfer.
It is normal for small amounts of water to remain in dispenser.
Fabric Damage Sharp items were in pockets
during wash cycle.
Strings and straps could have
tangled.
Items may have been damaged Mend rips and broken threads in seams before washing.
before washing.
Fabric damage can occur if the
load is tightly packed.
Liquid chlorine bleach may
have been added incorrectly.
Odors Clean washer maintenance not
done as recommended.
Not using HE detergent or using
too much HE detergent.
Do not overfill dispenser, which causes immediate dispensing.
Always select Fabric Softener option to assure proper dispensing.
Load dispensers before starting a cycle.
Homes with low water pressure may result in residual powder in the
dispenser. To avoid, select a warmer wash temperature if possible,
depending on your load, or use liquid HE detergent.
Use only liquid chlorine bleach in the bleach dispenser.
In wash water temperatures colder than 15.6 ° C (60° F), some
detergents do not dissolve well. Soils may be difficult to remove.
To avoid, select a warmer wash temperature if possible, depending
on your load, or use liquid HE detergent.
Empty pockets, zip zippers, and snap or hook fasteners before
washing to avoid snags and tears.
Tie all strings and straps before starting wash load.
Load garments in loose heaps evenly around the washplate.
Do not load garments directly over the center of the washplate.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 additional garments after washer has started.
Do not pour liquid chlorine bleach directly onto load. Wipe up bleach
spills.
Undiluted bleach will damage fabrics. Do not use more than
recommended by manufacturer.
Do not place load items on top of bleach dispenser when loading
and unloading washer.
Run the Clean Washer with affresh _*_ c ycle after every 30 washes.
See "Washer Care" in "Washer Maintenance."
Use only HE detergent. Be sure to measure correctly.
Always follow the detergent directions.
See "Washer Care" section.
Lid Locked light is on The lid is not closed. Close the lid. The washer will not start or fill with the lid open.
A cycle was stopped or paused The washer may still be spinning. The lid will not unlock until the
using the Start/Pause/Unlock basket has stopped spinning. This may take several minutes if
button, washing large loads or heavy fabrics.
16