Starting Your Washer; Using Laundry Product Dispensers; Select Cycle - Maytag 4GMVWX500 Manual De Uso Y Cuidado

Lavadora de carga superior y alto rendimiento, con nivel bajo de agua
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using Laundry Product Dispensers
Add HE detergent
to dispenser
Detergent tray
Fabric softener tray
i
Add a measured amount of HE detergent
into detergent tray. This tray holds 89 mL (3 oz.). Do not overfill
tray - adding too much detergent may cause detergent to be
dispensed into the washer too early.
iMPORTANT: Use only High Efficiency detergents. The package
will be marked "HE" or "High Efficiency." Low-water washing
creates excessive sudsing with a regular non-HE detergent.
Using regular detergent will likely result in longer cycle times and
reduced rinsing performance.
It may also result in component
failures and noticeable mold or mildew. HE detergents are made
to produce the right amount of suds for the best performance.
Follow the manufacturer's
instructions
to determine the amount
of detergent to use.
Using Oxi or color=safe bleach:
If using an Oxi or color-safe bleach laundry boost product, add
to the bottom of the washer basket before adding clothes.
HELPFUL TiP: See "Washer Maintenance" for information
on recommended
method of cleaning washer dispenser trays.
to dispenser
Do not overfill, dilute, or use more than 236 mL (1 cup). Do not
use color-safe bleach or Oxi products in the same cycle with
liquid chlorine bleach.
Pour a measured amount of liquid fabric
softener into tray, always follow manufacturer's
directions for
correct amount of fabric softener based on your load size. Close
dispenser drawer, then select Fabric Softener option.
iMPORTANT:
Fabric Softener option must be selected to
ensure proper distribution at correct time in cycle. Do not overfill
or dilute. Overfilling dispenser will cause fabric softener to
immediately dispense into washer.
If Extra Rinse option is selected, fabric softener will be dispensed
into the last rinse.
It is normal for a small amount of water to remain in the dispenser
at the end of a cycle.
Starting Your Washer
Press POWER to turn on washer
power
standby
0
cancel
Make sure the dispenser drawer is closed completely, then
press POWER/STANDBY/CANCEL
to turn on the washer.
7, Select cycle
normal
wrinkle control
hand
wash
clean
washer
&spin
rain & spin
Turn cycle knob to choose your wash cycle. For more
information, see "Control Panel".

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

4kmvwx505

Tabla de contenido