8.
Select cycle modifiers
O hot
Q warm
0 heavy
O high
0 cool
0 medium
Q low
Q cold
G light
Q no spin
modifiers
Once you select a cycle, the default settings for that cycle will
be lit. Press the cycle modifiers buttons to change the Temp
Level, Soil Level, and Spin Speed, if desired.
NOTE: Always read and follow fabric care labels instructions
to avoid damage to your garments.
Suggested Fabrics
Hot
Some cold water is added to save
energy. This may be cooler than
your hot water heater setting.
Whites and pastels
Durable garments
Heavy soils
Cool - brights/darks
Warm water is added to assist
in soil removal and to help
Colors that bleed
or fade
Cold
Warm water may be added to
Dark colors that
assist in soil removal and to help
bleed or fade
......
dissolve detergents.
Light soils
O. Press START/PAUSE/UNLOCK
to begin wash cycle
start
O
pause
unlock
Press the START/PAUSE/UNLOCK
button to start the wash
cycle. Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the DONE indicator
will light up. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE/UNLOCK;
the lid will unlock once
the washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close lid
and press START/PAUSE/UNLOCK
again to restart the cycle.
If lid is left open for more than 10 minutes the water will
pump out.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to
filling. This is normal operation.
9. Select
cycle options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically
add certain
options such as Extra Rinse. These can be turned off, if desired.
NOTE: Not all options are available with all cycles.
10