Selecting The Speed Setting; Filling While In Use; Removing The Blender - Silvercrest SSMC 600 B1 Guía Breve

Selecting the speed setting

Once the blender is filled and sitting completely closed on the motor block, you
can switch on the appliance.
Set the switch to ...
■
Level 1 – 3
for liquids or soft foodstuffs, for mixing, blending and stirring
■ Level 3 – 5
for more solid foods or for chopping
■ Level P (pulse function)
for short, powerful impulse operation, e.g. for crushing ice cubes or when
cleaning. To prevent overloading the motor, the switch does not lock in this
position. Therefore, hold the switch in this position for short periods only.
NOTE
► Fill the blender with a maximum of 250 ml of ice cubes.
Otherwise, the ice cubes will not be crushed optimally.

Filling while in use

WARNING!
► If you want to add additional foods during operation, use only the measuring
cap provided for this purpose. Do NOT open the lid.
► Do not insert cutlery items or mixing tools into the blender while the
appliance is in use. There is a considerable risk of injury if these come into
contact with the swiftly rotating cutting blades!
To add more food while the appliance is in use, ...
1) Remove the measuring cap from the lid.
2) Add the ingredients.
3) Press the measuring cap back into the lid.

Removing the blender

If you want to remove the blender from the motor block:
1) Always start by setting switch to the off position ("0") and pulling out the
mains plug.
2) Wait until the motor has come to a complete standstill before lifting the
blender off the motor block. Remove the blender from the motor block in a
vertical, upward motion.
SSMC 600 B1
GB │ IE │
7 ■