Switching On Or Off - Hilti NURON SC 30WR-22 Manual De Instrucciones Original

6.1 Switching on or off

Switching on
1. Press and hold down the switch-on interlock and press the on/off button.
▶ You can release the switch-on interlock as soon as you have the
on/off switch held down.
Switching off
2. Release the on/off switch.
▶ The switch-on interlock jumps automatically into the locked position.
6.2 Sawing along a line
The base plate has cutting line indicators for straight cuts (0°) A and bevel
cuts (45°) B. The edge of the line indicator corresponds to the inside of the
saw blade.
Saw only flat workpieces that offer a big enough contact surface to
accommodate the whole of the base plate.
1. Position the workpiece so that the saw blade is free to rotate beneath it.
2. Secure the workpiece to prevent movement.
3. Hold the saw in position with its base plate on the workpiece.
▶ Saw blade clear of the workpiece.
4. Switch the tool on. → page 19
5. Guide the saw along the cutting line at a suitable speed for it to cut
smoothly through the workpiece.
6.3 Using the saw on the guide rail
6.3.1 Rip cuts (cutting angle 0°)
Use the guide rail adapter for a saw with a small base plate.
1. Secure the guide rail with 2 screw clamps.
2. Set the saw on the guide rail with the 0° groove mark on the rib of the
guide rail.
3. Switch the tool on. → page 19
4. Advance the saw along the guide rail to make the cut through the
workpiece.
6.3.2 Bevel cuts (cutting angle 1° to 50°)
Use the guide rail adapter for a saw with a small base plate.
*2264108*
9
10
2264108
11
English 19