Fracarro SIG7120 Instrucciones De Uso página 21

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
To correctly install and configure the (SIG7120 or SIG7121) module, follow the operations listed below:
1. Install the module on the 19" sub-rack (SIG7901 or SIG7902) as explained before;
2. Use the supplied rigid jumper to connect the signal to other compatible New HeadLine modules (if present);
3. Connect the power supply to the 19" sub-rack;
4. Wait for the initialization of the module (the green LED flashes rapidly and the red LED is on);
5. Connect the TPE to the interconnection module of the 19" sub-rack and carry out the programming opera-
tions as specified in Chapter 5. PROGRAMMING INSTRUCTIONS.
IMPORTANT: The module needs about 30 seconds to complete the initial start-up phase and configure
the system; therefore, wait for the phase to be completed before starting any programming by means of
the TPE. Otherwise, the module might not be seen by the programmer and a new scanning of the head-
end could be necessary before being able to start programming it.
Green LED
OFF
Rapid flashing
Slow flashing
ON
ON
Slow flashing
ON
Rapid flashing
Slow Flashing
Slow flashing
ON
PENTA85
CHVU4ZN
FR
SAT
SIG7100
SIG7100
HEAD-Line
A
SIG7120
4. OPERATION INSTRUCTIONS
LEDs status table:
Red LED
OFF
ON
The modulator is in the start-up and system configuration phase
ON
OFF
Modulator fed correctly and Transport Stream detected at the input
Modulator fed correctly but no Transport Stream is detected at the
OFF
Presence of new parameters in the modulator not yet saved
ON
4.1 TYPICAL INSTALLATION EXAMPLE
External ASI
generators
ASI In
ASI In
HEAD-Line
R
SIG7120
SIG7121
HEAD-Line
HEAD-Line
L
SIG7121
SIG7121
V
DTT
DTT
DTT
A
V
COFDM
OUTPUT
Meaning
The modulator is off
Modulator boot-up
Modulator under an overheating or overflow alarm
Modulator fed correctly but there is an internal anomaly
PENTA85
CHVU4ZN
FR
SIG7100
21
input
SIG7120
max 3
SAT
SAT
SAT
HEAD-Line
HEAD-Line
HEAD-Line
R
R
R
SIG7120
SIG7120
SIG7120
L
L
L
V
V
V
SIG7100
SIG7100
SIG7100
HEAD-Line
HEAD-Line
DTT
DTT
DTT
HEAD-Line
A
A
V
A
A
V
A
A
T75IF
COFDM
OUTPUT
HEAD-Line
SIG7120
SIG7120
DTT
V

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sig7121

Tabla de contenido