Fracarro SIG7120 Instrucciones De Uso página 28

Continuation from ALL
PIDs OUT menu
ADVANCED
CONFIG
Transport Stream ID
setting menu
Enable/Disable signal
properties (coded flag)
Confirm the settings by pressing the
TS LOOP-THROUGH – it is possible to use this control to enable or disable the distribution to adjacent modules
from the transport stream on the back-panel. By disabling the loop-through TS in the first modulator, the content
reception of the module itself is not affected, but the reception in the following modulators is interrupted.
UPDATE LIST IN – updates the channel list from the digital receiver input.
IMPORTANT: the modulator automatically update the input channel list; therefore, a manual update must
be carried out after modifying the reception settings of the receiver module or after activating the loop-
through TS in the modulator before it.
Do the manual updating after enabling the loop-through TS in the module before it.
CHANNEL LIST IN – displays the list of channels present at the transport stream input. For every list channel
the submenus are the following::
• ADD: adds the selected channel to the list of channels to be distributed at the output;
• REMOVE: removes the selected channel from the list of channels to be distributed at the output;
• CHANNEL PROP. : provides information about the properties of the channels in the input list. The following
submenus are available:
• PROGRAM NAME: provides the program name
• PROGRAM TYPE: provides information on the program type
• SERVICE ID: provides information on the service identification code.
• BITRATE USED: provides information about the used bitrate. This parameter refers to the total measure-
ment of all channels added to the output channel list.
• BITRATE AVAIL. : provides information of the available bitrate. This parameter refers to the total measure-
ment of the available bitrate at the output after inserting one or more channels.
CHANNEL LIST OUT – displays the output channel list selected from the list of available channels at the input.
For every list channel the submenus are the following:
• POSITION: shows the position occupied by the selected channel in the priority queue of output channels
(see paragraph 5.2),
• REMOVE: removes a single selected channel from the output channel list; in particular, if there are channels
from previous settings, this control is an alternative to setting the whole channel list to zero.
• LCN CONF: enable/disable LCN (Logical Channel Number) function for selected program;
• LCN SET: set the LCN number for selected program
CLEAR LIST OUT – completely sets the output channel list to zero.
PID MANAGEMENT – manages the available services; it is useful in particular distribution conditions. The fol-
lowing can be set:
Original Network ID
setting menu
SET ONID
SET TS ID
HEADEND DECRYPT.
key; save the settings by pressing the
S key after the modules programmation.
28
Increase/decrease from TPE by
using the arrow keys, or enter
0 65535
the value directly from the
keyboard.
Increase/decrease from TPE by
using the arrow keys, or enter
0 65535
the value directly from the
keyboard.
ON OFF