Fracarro SIG7120 Instrucciones De Uso página 27

Continuation from
CHANNEL LIST IN menu
View the output
channel list, their
CHANNEL LIST OUT
position in the priority
queue and allow to
delete one by one.
Clear the output
channel list
CLEAR LIST OUT
Manual
management of the
PID, it is possible to
PID MANAGEMENT
add or remove PID
and visualize the
list of the added or
removed PID.
TS source selection
(back panel or ASI
TS IN SELECTION
connector) Available
only for SIG7121
Enable/Disable All
PIDs programs
ALL PIDs OUT
through the output
ADVANCED CONFIG menu
continues at following page
< ( ) Channel 1 >
< ( ) Channel 2 >
< ( ) Channel N >
ADD PID
Show Added PID
ADDED PID LIST
list
REMOVE PID
Remove PID menu
Show the Cut
CUT PID LIST
PID list
Clear the Added
CLEAR ADDED PIDs
PIDs from the list
Restore Cut PIDs
RESTORE CUT PIDs
function
parallel
Disable
Enter
with
POSITION
REMOVE
LCN CONF.
LCN SET
Refer to the same
programming menu of
Channel 1
Insert value directly
from TPE numeric
keyboard.
ADDED PID LIST
< -- >
Insert value directly
from TPE numeric
keyboard.
CUT PID LIST <
xxx >
ASI TS available on the BNC front connector
ASI
Parallel TS available from back-panel
Disable Standard program management
Enable
Enable Enable of all Programs Pids throug
the output
27
Selection of program
priority sended to the
COFDM modulator
X/X
1/X
Enable
Disable
Increase/decrease by using
TPE arrows
0 - 999 LCN
0
1000
1000
Disable
Insert value directly
from TPE numeric
keyboard.
CUT PID
Scroll PID list by using
TPE arrows
RESTORE PID