Publicidad
Step 7
Fasten the TOP MOLDING (P) to the FRONT MOLDING (M). Use
å
two BLACK 9/16" LARGE HEAD SCREWS (II) through the ANGLE
BRACKETS and into the TOP MOLDING.
NOTE: There are no pre-drilled holes in the TOP MOLDING. The
å
SCREWS will tighten into the groove. Do not overtighten.
Fasten the CATCH BRACKET (T) to the FRONT MOLDING (M). Use
å
two BLACK 9/16" LARGE HEAD SCREWS (II).
Fasten the MAGNETIC CATCH (U) to the CATCH BRACKET (T).
å
Use one BLACK 1-1/8" PAN HEAD SCREW (HH) in the hole shown
in the enlarged diagram.
P
M
www.sauder.com/services
BLACK 9/16" LARGE HEAD SCREW
(4 used for the BRACKETS)
401867
BLACK 1-1/8" PAN HEAD SCREW
(1 used for the MAGNETIC CATCH)
II
T
HH
U
Page 11
Publicidad
