Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
APPLICATIONS
<DV18DBL2>
○ Use as a hammer drill
Drilling of soft bricks and concrete blocks.
<DS18DBL2 / DV18DBL2>
○ Use as a drill
Drilling of soft steel, wood, plastic and aluminum
materials.
○ Use as a screwdriver
Tightening and loosening of machine screws, wood
screws and tapping screws.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 6).
Latch
Battery
Pull out
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
10
ASSEMBLY AND OPERATION
Handle
Push
Insert
Fig. 6
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
Fig. 7, 8.
<UC18YFSL>
Pilot lamp
Charger
<UC18YSL3>
Charge
indicator lamp
3. Charging
<UC18YFSL>
When the battery is connected to the battery charger,
charging will commence and the pilot lamp will light in
red. (See Table 2)
Battery
Fig. 7
Battery
Guide rail
Fig. 8
Publicidad
Tabla de contenido
