Honda XR250 Tornado 2017 Manual Del Propietário página 173

76
Installation Notes
Reverse the removal procedure.
P
Insert the front axle shaft through the wheel hub
P
and left fork leg. Make sure that the tang (5) on
the speedometer gearbox is located behind the
tang (6) on the right fork leg.
(6)
(5) Tang
(Speedometer
gear box)
(6) Tang
(5)
(Right fork leg)
Tighten the front axle shaft to the specified torque.
P
Front axle shaft torque:
59 N.m (6.0 kgf.m; 44 lbf.ft)
Tighten the upper axle holder nuts to the specified
P
torque first, then tighten the lower axle holder nuts
to same torque.
Axle holder nut torque:
12 N.m (1.2 kgf.m; 9 lbf.ft)
After installing the wheel, apply the brake several
P
times and then check if the wheel rotates freely.
Recheck the wheel if the brake drags or if the wheel
does not rotate freely.
C
!
aution
If a torque wrench was not used for installation,
see your Honda dealer as soon as possible to verify
proper assembly. Improper assembly may lead to
loss of braking capacity.
XR250 TORNADO