Wheels; Front Wheel Removal - Honda XR250 Tornado 2017 Manual Del Propietário

XR250 TORNADO
3. Lower the side stand. The engine should stop as
you put the side stand down.
If the side stand system does not operate as described,
see your Honda dealer for service.
(1)
(1) Side stand spring

Wheels

(Refer to the Safety Precautions on page 55.)

Front Wheel Removal

1. Raise the front wheel off the ground by placing a
support block under the engine.
2. Remove the speedometer cable set screw (1) and
disconnect the speedometer cable (2).
3. Loosen the axle holder nuts (3).
4. Unscrew the front axle shaft (4). Remove the
wheel.
Do not depress the brake lever when the wheel is off
the motorcycle. The caliper piston will be forced out
of the cylinder with subsequent loss of brake fluid.
If this occurs, servicing of the brake system will be
necessary. See your Honda dealer for this service.
(2)
(1)
(4)
(3)
75
(1) Speedometer
cable set screw
(2) Speedometer
cable
(3) Axle holder nuts
(4) Front axle shaft