Maintenance - SPARKY BR2 12E Instrucciones De Uso Originales

sonry impact bits when drilling holes in brick, tile, con-
crete etc.
the torque collar to the drill position.
sults in brick.
terials such as concrete.
determine the best speed and pressure.
Drilling wood
bits for wood drilling.
position "drill bit".
bit from slipping off the starting point. Increase the
speed as the drill bites into the material.
behind the work piece to prevent ragged or splintered
edges on the back side of the hole.
or nail.
Select the appropriate torque by placing one of the
numbers, marked on the torque adjustment collar (2),
against the arrow on the tool body.
Insert the necessary bit.
Over-tightening can result in the
screw breaking or damage to the end of the driver bit.
If the machine is held at an angle
to the screw being tightened, the head of the screw
transmitted to the screw. Always keep the machine
and the screw being tightened in a straight line.
Always wear eye protection.
Turn the torque adjustment collar (2) to the "drill bit"
position and select low gear, on the speed selector
switch (3). Tighten the chuck around the shorter end of
a hex key (not supplied) of 5 mm or greater size. Using a
wooden mallet or similar object, strike the longer end in
the clockwise direction. This will loosen the left-thread-
ed screw inside the chuck.
Original instructions
- 1. Open chuck jaws fully.
2. Insert a 5 mm hex key into front of chuck between
jaws to engage screw head. Remove screw by turn-
ing clockwise.
3. Place the hex key in chuck and tighten. Using a
wooden mallet or similar object, strike key sharply
-
in the anti-clockwise direction. This will loosen the
chuck so that it can be unscrewed by hand.
-
1. Screw the chuck on by hand as far as it will go and
insert screw (left-threaded).
2. Tighten the chuck around the shorter end of hex key
(not supplied) strike the longer end in the clockwise
direction with a wooden mallet.
3. Remove the hex key and open the jaws fully. Tighten
the screw in the centre of the chuck with the hex key
in an anti-clockwise direction.
Charger, two Ni-Cd battery packs and two double-ended
screwdriver bits.

Maintenance

move the battery before performing any adjustments
or maintenance procedures.
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Re-lubricate all moving parts at regular intervals.
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch-
es. Use a soft brush to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
cleaning agent. Never use caustic agents to clean
plastic parts.
tact with the tool.
To assure product safety and reliability, re-
pairs, maintenance and adjustment (including brush inspec-
using genuine replacement parts.
Always switch the tool off and re-
Never use alcohol, petrol or other
Water must never come into con-
-
-
9
EN