Electrolux MKTG15DNAWB Manual Del Uso Y Cuidado página 42

42
Washer
Washer pauses
during the spin
cycle
Can hear but not
see the water at
the end of the cycle
Performance
(washer)
Washer won't
operate
Movement inside
machine when
turned o
All manuals and user guides at all-guides.com
Possible causes
This is
normal
This is
normal
Possible causes
Washer is disconnected
Water supply
is turned o
Controls are not
set properly
Lid is open – the
safety feature is
preventing agitation
and spinning when
the lid is open
The circuit breaker/
fuse is tripped/blown
Electronics need
to be reset
START was not pressed
Lid magnet is missing
Shifting mechanism is
disengaging to return
to initial position
(only in spin)
What to do
The washer can be paused during the
spin cycle to remove water containing
soap more e ciently.
Pump is leaving water at inlet and it is
diluted with soap and clean water.
What to do
Make sure cord is connected securely into a
working outlet.
Turn both hot and cold faucets fully on.
Check controls.
Close lid and restart cycle, from the
beginning if necessary.
Check house circuit breakers/fuses.
Replace fuses or reset breaker.
Washer should have a separate outlet.
isconnect washer, wait 2 minutes, connect
D
and press START.
Press START.
Call for service.
When the machine is turned o manually,
the shifter will disengage the motor
before completely shutting down
(only in spin).
If the lid is raised before the motor is
disengaged, it will resume when lid is
closed (only in ll and wash).