Hitachi RAS-25CNH2 Manual De Instrucciones página 18

2. Washable Front Panel
G The front panel remove and can wash with clean
water in whole.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with
clean water.
G When it is not removed, wipe it with a soft dry
cloth. Wipe the remote controller thoroughly with a
soft dry cloth.
G Wipe the water thoroughly.
If the water remains at indicators or signal receiver
of indoor unit, it causes trouble.
Method to remove of the suction grille.
Be sure to hold the suction grille with both hands
to detach and attach it.
Removing the Front Panel
G When the front panel is fully opened with
both hands, push the right arm to the inside
to release it, and while closing the front panel
slightly, put it out forward.
!
CAUTION
G Do not splash or direct water to the body of the unit when cleaning
it as this may cause short circuit.
G
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or
a brush, because they will damage the plastic surface and the coating.
Arm
G Move the projections of the left and right
arms into the Flanges in the unit and
securely insert them into the holes.
– 18 –
Attaching the Front Panel
Flange
Projection
Hole