Publicidad
Idiomas disponibles
Idiomas disponibles
Safety
Electrical connection
All installation must be carried out by a qualified electrician.
Before connecting the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains using
an omnipolar circuit breaker with a minimum opening of 3 mm
between the contacts.
The installer must ensure that the correct electrical connection
has been made and that it complies with the wiring diagram.
The cable must not be bent or compressed.
Regularly check the power cord for damage. If the supply cord
is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a safety hazard.
WARNING: This is a Class I appliance and MUST be earthed.
• This appliance is supplied with a 3 core mains cable coloured as
follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
This appliance should be connected directly to the consumer
unit with a 3 Amp Residual Current Device (RCD) protecting its
circuit.
To avoid the risks that are always present when you use an
electrical appliance it is important that this appliance is installed
correctly and that you read the safety instructions carefully to
avoid misuse and hazards. Please keep this instruction booklet
for future reference and pass it on to any future owners. After
unpacking the appliance please check that it is not damaged. If in
doubt, do not use the appliance but contact Customer Services.
211859_s1_s6-5059340158020-C&L-A5-SM-Safety-V04-Multi.indd 7
211859_s1_s6-5059340158020-C&L-A5-SM-Safety-V04-Multi.indd 7
07
25-03-2021 14:29:56
25-03-2021 14:29:56
Publicidad
