Bevel Cutting - Ryobi CSB144LZ Manual Del Operador

WARNING:
Use clamps or other practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body is unstable and
may lead to loss of control which could cause possible
serious injury.
To make the best possible cut:
 Hold the saw firmly with both hands.
 Avoid placing your hand on the workpiece while making
a cut.
 Support the workpiece so that the cut (kerf) is always to
your side.
 Support the workpiece near the cut.
 Clamp the workpiece securely so that the workpiece will
not move during the cut.
 Always place the saw on the workpiece that is supported,
not the "cut off" piece.
 Place the workpiece with the "good" side down.
 Draw a guideline along the desired line of cut before
beginning your cut.
 Keep the cord away from the cutting area. Always place
the cord to prevent it from hanging up on the workpiece
while making a cut.
DANGER:
If the cord hangs up on the workpiece during a cut,
release the switch immediately and allow the blade to
come to a complete stop. Unplug the saw and reposition
the cord to prevent it from hanging up again.
WARNING:
Using a saw with a damaged cord could result in serious
injury or death. If the cord has been damaged, have it
replaced before using the saw again.
CROSS CUTTING/RIP CUTTING
When making a cross cut or rip cut, align the line of cut with
the outer blade guide notch on the base as shown in the figure.
Since blade thicknesses vary, always make a trial cut in scrap
material along a guideline to determine how much, if any,
you must offset the guideline to produce an accurate cut.
NOTE: The distance from the line of cut to the guideline is
the amount you should offset the guide.
All manuals and user guides at all-guides.com
OPERATION
USING AN EDGE GUIDE
See Figures 16 - 17, page 18.
Use the edge guide provided when making long or wide rip
cuts with the saw.
To install the edge guide:
 Unplug the saw.
 Place edge guide through slots in base.
 Adjust edge guide to the width needed.
 Tighten edge guide lock knob securely.
To use the edge guide:
 Secure the workpiece.
 Position the face of the edge guide firmly against the edge
 Guide the saw along the edge to achieve a straight rip
TO RIP CUT WITHOUT EDGE GUIDE
See Figure 18, page 18.
Use a guide when making long or wide rip cuts with the saw.
 Secure the workpiece.
 Clamp a straight edge to the workpiece using C-clamps.
 Saw along the straight edge to achieve a straight rip cut.

BEVEL CUTTING

See Figures 19 - 21, page 18.
To make the best possible cut, follow these helpful hints.
 Align the line of cut with the inner blade guide notch on
 Make a trial cut in scrap material along a guideline to
 Adjust the angle of the cut to any desired setting between
TO ADJUST BEVEL SETTING
See Figures 19 - 20, page 18.
 Unplug the saw.
 Loosen bevel lock knob.
 Rotate motor housing end of saw until you reach desired
 Tighten bevel lock knob securely.
11 - English
of workpiece.
cut.
NOTE: The guiding edge of the workpiece must be
straight for the cut to be straight. Use caution to prevent
the blade from binding in the cut.
NOTE: Do not bind the blade in the cut.
the base when making 45° bevel cuts.
determine how much you should offset the guideline on
the cutting material.
zero and 51.5°. Refer to To Adjust Bevel Setting next.
angle setting on bevel scale.
WARNING:
Attempting a bevel cut without having the bevel lock knob
securely tightened can result in serious injury.