Environmental Concerns - Electrolux ERT17004W8 Manual De Referencia Rápida

Ocultar thumbs Ver también para ERT17004W8:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

12 electrolux
3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom hinge.
5. Take off the appliance door by pulling it slight-
ly downwards.
6. Unscrew the top door hinge pin of the appli-
ance then screw it back on the other side.
7. Fit the appliance door on the upper door
hinge pin.
8. Remove the lower hinge. Put over the pin in
the direction of the arrow.
9. Unscrew and install the screw on the oppo-
site side.
10. Install the lower hinge on the opposite side
leaving the position of the door unchanged.

ENVIRONMENTAL CONCERNS

The symbol
on the product or on its
packaging indicates that this product may not be
treated as household waste. Instead it should be
8) If foreseen
11. Screw in the one screw in the place set free
on the other side as well as the adjustable
feet (2 pieces).
12. Remove and install the handle
site side.
13. Reposition, level the appliance, wait for at
least four hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-
cialist will carry out the reversibility of the doors at
your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate
earth in compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
taken to the appropriate collection point for the
recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly,
8)
on the oppo-

Publicidad

Tabla de contenido
loading

Tabla de contenido