Opening The Case; Closing The Lid - KTM Top Case 46 Instrucciones De Montaje

8
7
9
4
1
60012027250
(950 Adventure)
5
6
Scope of supply:
1pc. Pos.1
(4pc. Pos.2
(4pc. Pos.3 M6x30) *
4pc. Pos.4 Ø6 ESP
4pc. Pos.5 Ø6
4pc. Pos.6 M6
1pc. Pos.7
3pc. Pos.8 M5x12
4pc. Pos.9 M6x20
Accessories: page 7
Situate the bottom rack of the TOP CASE [1] in the assembly position,
screw in with the screws [9], the special washers [4], the washers [5]
and the nuts [6]. Tighten all the screws and fit the covers [7] in their
housings with the screws [8]. The adaptable rack fits all Top Master
and Full Master models. Just follow the instructions for each model.

OPENING THE CASE

Lift the handle. Then lift the central tab as shown in the diagram. Once
you have done this, the ejector will lift the lid of the case just enough to
release it from the interior catches. Finally, take hold of the
overhanging part of the case lid and lift the lid with your hand, as
shown in the diagram.

CLOSING THE LID

To close the lid, let it drop down and then press it down with both
hands, as shown in the diagram, until you hear the catches click into
place. Make sure it is properly closed by pulling up the overhanging
part of the lid to see whether it will open.
)*
*is not required
3